[3 Fixes] Apex Digital TV Converter Box Won’t Turn On

Share on:

Analog cable services have started going extinct in recent years. Nowadays, cable providers have also gone digital and so, a digital TV converter box such as the Apex digital TV converter box is needed. But just like any electronic device, this can also create issues including not turning on.

It is quite easy to fix the issues of your Apex digital TV converter box such as if it is not turning on. You can try to smolder some cables together to make it work. You can also simply unplug the power and plug the device back in to try and fix the issue.

Here in this article, we will go into more detail and show you the methods to fix your Apex digital TV converter box if it won’t turn on.

Apex Digital TV Converter Box Won't Turn On

How You Can Fix Your Apex Digital TV Converter Box if It Won’t Turn On

A few quick methods to fix your Apex digital TV converter box are given below –

Method 1: Unplug the Power Cord

Simply unplugging the power cords can help. Here’s what to do –

  1. Turn off your Apex digital TV converter box.
  2. Unplug the power cable.
  3. Wait for about 30 seconds so the box resets itself.
  4. Plug the power cable back in.
  5. Turn on the device.

In most cases, this would fix the issue. If not then try the next method.

Method 2: Fix the Coaxial Cable

If the coaxial cable is loose, damaged, or dirty then it could cause issues while trying to turn on the Apex digital TV converter box. Try these fixes below –

  • Clean the cable if dirty.
  • Replace the cable if there are any damages on the cable.
  • Tighten the cable by hand. Tighten both the wall outlet end and the end that goes into your converter box by hand.

If the coaxial cables are fine then you can try the next method instead.

Method 3: Solder the Component Capacitors

This may look complicated and tricky at first but this is another way you fix your digital converter box. But first, buy new C8 component capacitors from your local hardware store or online. Now, follow the steps below –

Step 1: Turn off the converter box.

Step 2: Remove the back cover.

Step 3: Locate the C8 Component capacitors.

Step 4: Use a solder gun to remove them.

Solder the new capacitors in place and make sure the positive (+) and negative (-) ends are properly placed.

Clip the wires shorter if necessary.

Step 5: Place the back cover and screw it back on.

Step 6: Turn on the device.

By soldering new capacitors, your Apex digital TV converter box will work.

Frequently Asked Questions (FAQs)

Will a converter box work without an antenna?

No, a converter box will not work without an antenna. You will need to install an antenna for it to work. There are many indoor antennas but make sure that the place where you live has a signal.

Can a universal remote work on a converter box?

Yes, a universal remote will work on a converter box. You will need to program the universal remote for it to work.


In conclusion, the soldering technique is the best method to go for since it has had a 100% success rate. Although a bit tricky, it is the most useful way of fixing your device. We hope we were able to help you with your Apex Digital TV Converter Box if it won’t turn on. If you need further assistance, please do not hesitate to contact us in the comments section.

About The Author

Leave a Comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.